Solutions Sealers Pavacryl Hard Coat- High Solids Acrylic Sealer

PAVACRYL is a top-tier solvent-based acrylic sealer specifically designed to provide superior protection and durability for driveways and other high-traffic areas. With its high solids content and high hardness point, PAVACRYL ensures long-lasting performance and resistance to wear and tear. This high-performance sealer delivers a striking wet look finish, darkening the substrate and enhancing its natural appearance. It’s robust coating effectively prevents the ingress of oils and dirt, keeping your surfaces clean and well-maintained.

Suitable for internal and external use on all masonry driveways and heavy-use areas, including exposed aggregate, plain concrete, and stamped concrete.  PAVACRYL combines quality, longevity, and aesthetic enhancement, making it the perfect choice for driveway protection.

Features:

• Solvent-based
• High solids content
• Suitable for heavy traffic areas
• Wet look finish
• Darkens substrate
• Prevents oils and dirt ingress

Preparation:

Always test the product on a small area first and allow a 1-hour cure time to determine the ease of application and suitability for your surface type. For new grout, allow 48 hours, and for new concrete, allow 28 days before application.

All surfaces should be thoroughly cleaned with NATURAL CLEAN. Heavily soiled, acid-sensitive surfaces should be cleaned with D-GREASE, while non-acid-sensitive surfaces can be cleaned with D-SCALE. All surfaces should then be neutralized with NATURAL CLEAN.

Allow the surface to dry for approximately 24 hours before sealing. Ensure the surface is clean and free of residue and other contaminants. Tape or protect nearby surfaces. Ensure proper ventilation and use the appropriate PPE as per the SDS.

Coverage:

Porous surfaces first coat 4-5 square metres per litre, 2nd and third coats 7 and 10 square metres per litre respectively

Application:

Apply when the surface temperature is between 5–35°C. Use a Solutions Sealers applicator, lambswool roller, microfiber, or paintbrush. For most porous surfaces, mix the first coat with 50% Eversol (Xylene) to aid adhesion to the substrate. 2-3 coats are recommended, with the last coat at 100% strength. Apply the coats slowly without agitation to avoid air bubbles within the coat. Apply a wet coat without leaving pools of sealer. Seal across the area following the wet line. The sealer will tack off in approximately 15 minutes and be ready for another coat within 1-2 hours.

Do not allow the sealer to contact painted surfaces, plastic, vinyl, etc.

Download and read all the datasheets prior to application.

Visit Solutions Sealer to learn more about this product.

Contact Sydney Industrial Coatings for any inquiries.